LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1124 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tires. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    3. Fig 1: View Of Left And Right Stabilizer Shaft Insulators And Brackets
    GM623050Courtesy of GENERAL MOTORS CORP.
  3. Remove the side stabilizer shaft insulator bracket bolts.
  4. Use a pry bar in order to remove the stabilizer shaft insulator brackets.
  5. Remove the stabilizer shaft insulators (4).
scientia non olet · About LEMON Manuals