LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1121 (Engine Mechanical - 3.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Rear Bearing Hole Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
    2. Fig 1: View Of Camshaft Rear Bearing Hole Plug
    GM105921Courtesy of GENERAL MOTORS CORP.
  2. Remove the camshaft rear bearing hole plug.
scientia non olet · About LEMON Manuals