LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1121 (Engine Mechanical - 3.4L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Rocker Arm and Push Rod Removal

Valve Rocker Arm and Push Rod Removal

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Valve Rocker Arm
    GM54392Courtesy of GENERAL MOTORS CORP.
  1. Remove the valve rocker arm bolts.
    2. IMPORTANT: Place the valve train components in a rack in order to ensure that the components are installed in the same location from which they were removed.
  2. Remove the valve rocker arms.
    3. Fig 2: View Of Push Rods
    GM187046Courtesy of GENERAL MOTORS CORP.
  3. Remove the push rods.
    • The intake push rods measure 146 mm (5.75 in).
    • The exhaust push rods measure 152.51 mm (6.0 in).
    4. Fig 3: Intake Manifold Gaskets
    GM61187Courtesy of GENERAL MOTORS CORP.
  4. Remove the intake manifold gaskets.
scientia non olet · About LEMON Manuals