LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1120 (Engine Mechanical (Repair Instructions 1 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 1) >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Flywheel
    GM902811Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission. Refer to Transmission Replacement (LY7) in Automatic Transmission - 4T65-E.
  2. Remove the engine flywheel bolts and the flywheel. Refer to Engine Flywheel Removal .
  3. Clean and inspect the flywheel. Refer to Engine Flywheel Cleaning and Inspection . If the flywheel teeth are damaged, inspect the starter for proper operation. Replace the starter if there is excessive wear or damage to the starter drive. Refer to Starter Motor Replacement (LY7) in Engine Electrical.
scientia non olet · About LEMON Manuals