LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1120 (Engine Mechanical (Repair Instructions 1 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 1) >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the right engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  2. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    3. Fig 1: View Of Tensioner & Drive Belt Routing
    GM1394083Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt to the accessory drive pulley.
  4. Rotate the drive belt tensioner clockwise.
  5. Install the drive belt to the generator.
    6. IMPORTANT: Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
  6. Slowly release the drive belt tensioner.
scientia non olet · About LEMON Manuals