LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1120 (Engine Mechanical (Repair Instructions 1 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 1) >> Camshaft Position (CMP) Actuator Replacement - Bank 2 (Left) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Camshaft Position (CMP) Actuator
    GM946219Courtesy of GENERAL MOTORS CORP.
  1. Install the camshaft position actuator to the timing chain.
    2. NOTE: Refer to Torque Reaction Against Timing Drive Chain Notice in Cautions and Notices.
  2. Install the camshaft. Refer to Camshaft Replacement - Left .
scientia non olet · About LEMON Manuals