LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1119 (Frame And Underbody) >> Repair Instructions >> Frame Cushion or Insulator Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Vehicle Lifting and Jacking in General Information.
    2. Fig 1: View Of Rear Frame
    GM319192Courtesy of GENERAL MOTORS CORP.
  2. Remove the intermediate shaft from the steering gear stub shaft. Refer to Intermediate Steering Shaft Replacement in Power Steering.
  3. Install a utility stand to the rear of the frame.
  4. Remove the rear frame bolts.
  5. Lower the rear of the frame.
  6. Remove the upper and lower insulators from the rear of the frame as a set.
scientia non olet · About LEMON Manuals