LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1119 (Frame And Underbody) >> Repair Instructions >> Frame Cushion or Insulator Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Frame
    GM319192Courtesy of GENERAL MOTORS CORP.
  1. Apply a thin coat of rubber lubricant GM P/N 1051717, Canadian P/N 5728223, to inside surface of lower insulator and to top surface of upper insulator.
  2. Install the upper and lower insulators to the rear of the frame as a set.
  3. Raise the rear of the frame.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the rear frame bolts.

    Tighten:  Tighten the rear frame bolts to 240 N.m (177 lb ft).

  5. Remove the utility stand.
  6. Install the intermediate shaft to the steering gear stub shaft. Refer to Intermediate Steering Shaft Replacement in Power Steering.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals