LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1119 (Frame And Underbody) >> Repair Instructions >> Frame Cushion or Insulator Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the steering intermediate shaft. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
  3. Install a jackstand under the center of the frame, between the front frame insulators.
    4. Fig 1: View Of Front Frame Bolts And Retainers
    GM319188Courtesy of GENERAL MOTORS CORP.
  4. Remove the front frame bolts and retainers.
  5. Lower the front of the frame.
  6. Remove the frame front upper insulators.
    7. Fig 2: View Of Frame Front Upper Insulators
    GM777204Courtesy of GENERAL MOTORS CORP.
  7. Install the J 45296  to the front frame insulator you are removing. See Special Tools and Equipment .
  8. Using J 45296  , remove the front frame insulator from the frame. See Special Tools and Equipment .
scientia non olet · About LEMON Manuals