Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rearview Mirror Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector (3) from the back of the mirror.
Remove the wire harness cover.
Adjust the mirror to the full upward position.
Remove the base trim cover.

Fig 2: Removing/Installing Rearview Mirror

Courtesy of GENERAL MOTORS CORP.

Loosen the screw at the base in order to remove the mirror from the button.
Slide the mirror in an upward motion in order to remove.