LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1116 (Wiper System & Washer System) >> Repair Instructions >> Washer Hose Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear washer hose to the inner right side of the vehicle.
  2. Fig 1: Identifying Washer Nozzle
    GM755878Courtesy of GENERAL MOTORS CORP.
  3. Route the rear washer hose through the inside of the rear roof panel.
  4. Route the rear washer hose through the liftgate rubber conduit.
  5. Install the rear washer nozzle. Refer to Washer Nozzle Replacement - Rear .
  6. Fig 2: View Of Rear Washer Hose In Right Rear Quarter Panel Area
    GM755877Courtesy of GENERAL MOTORS CORP.
  7. Position the rear washer hose to the right rear quarter panel area and secure with tape.
  8. Fig 3: Locating Rear Washer Hose On Right Sill Area
    GM756256Courtesy of GENERAL MOTORS CORP.
  9. Position the rear washer hose to the right sill area and secure with tape.
  10. Fig 4: View Of Washer Hose
    GM755860Courtesy of GENERAL MOTORS CORP.
  11. Install the rear washer hose through the opening in the right side of the instrument panel.
  12. Connect the rear washer hose to the rear washer pump.
  13. Install the right rear lower quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Lower (Aztek) or Trim Panel Replacement - Rear Quarter Lower (Rendezvous) in Interior Trim.
  14. Install the right lower center pillar molding. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  15. Install the right cowl trim panel. Refer to Trim Panel Replacement - Cowl Side in Interior Trim.
  16. Install the right closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.