LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1115 (Engine Cooling System) >> Repair Instructions >> Radiator Hose Replacement - Inlet (LA1) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Radiator Hose Clamp
    GM368786Courtesy of GENERAL MOTORS CORP.
  1. Install the radiator inlet hose.
  2. Connect the radiator inlet hose to the radiator.
  3. Reposition the hose clamp at the radiator to secure the hose using theJ 38185  . See Special Tools and Equipment .
  4. Connect the radiator inlet hose to the thermostat housing.
  5. Reposition the hose clamp at the thermostat housing to secure the hose using theJ 38185  . See Special Tools and Equipment .
  6. Fill the cooling system. Refer to Draining and Filling Cooling System .
scientia non olet · About LEMON Manuals