LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1115 (Engine Cooling System) >> Repair Instructions >> Cooling Fan Motor Replacement - Electric >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Electric Coolant Fan Caution in Cautions and Notices.
    CAUTION: Refer to Damaged Fan Blade Caution in Cautions and Notices.
    IMPORTANT: If abnormal noise or vibration is felt from the engine compartment, inspect and clean any foreign material from the cooling fan blades.
  1. Turn the ignition off.
  2. Remove the cooling fan and shroud assembly. Refer to Cooling Fan Replacement - Electric (LA1)  or Cooling Fan Replacement - Electric (LY7) .
    3. IMPORTANT: Turn the cooling fan nut clockwise to loosen.
  3. Remove the cooling fan nut.
    4. Fig 1: Identifying Cooling Fans
    GM793515Courtesy of GENERAL MOTORS CORP.
  4. Remove the cooling fan from the shroud.
  5. Disconnect the electrical connector from the cooling fan motor.
    6. Fig 2: Locating Cooling Fan Motor Screws
    GM793513Courtesy of GENERAL MOTORS CORP.
  6. Remove the screws from the cooling fan motor.
  7. Remove the cooling fan motor.
scientia non olet · About LEMON Manuals