LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1115 (Engine Cooling System) >> Repair Instructions >> Cooling Fan Motor Replacement - Electric >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Cooling Fan Motor Screws
    GM793513Courtesy of GENERAL MOTORS CORP.
  1. Install the cooling fan motor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws to the cooling fan motor.

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

  3. Connect the electrical connector to the cooling fan motor.
    4. Fig 2: Identifying Cooling Fans
    GM793515Courtesy of GENERAL MOTORS CORP.
  4. Install the cooling fan to the shroud.
    5. IMPORTANT: Turn the cooling fan nut counterclockwise to tighten.
  5. Install the cooling fan nut.

    Tighten:  Tighten the nut to 6 N.m (53 lb in).

  6. Install the cooling fan and shroud assembly. Refer to Cooling Fan Replacement - Electric (LA1)  or Cooling Fan Replacement - Electric (LY7) .
scientia non olet · About LEMON Manuals