LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1115 (Engine Cooling System) >> Repair Instructions >> Coolant Pipe Replacement - Inlet >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Coolant Inlet Pipe Bolts & Coolant Inlet Pipe
    GM1395459Courtesy of GENERAL MOTORS CORP.
  1. Drain the coolant until the coolant level is below the lower radiator hose. Refer to Draining and Filling Cooling System .
  2. Remove the lower radiator hose from the coolant inlet pipe. Refer to Radiator Hose Replacement - Outlet (LA1)  or Radiator Hose Replacement - Outlet (LY7) .
  3. Remove the water coolant inlet pipe bolts and the coolant inlet pipe.
  4. Remove and discard the coolant inlet pipe seal.
scientia non olet · About LEMON Manuals