LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the screw from the front of the rocker panel molding.
  2. Remove the top edge of the rocker panel molding by pulling off to release the push-in retainers.
    Fig 1: View Of Rocker Panel Push-In Retainers
    GM621022Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.
  3. Release the push-in retainers from the lower rocker panel molding using a small flat-bladed tool inserted between the rocker panel molding and the retainer.
  4. Remove the rocker panel molding from the rocker panel.
scientia non olet · About LEMON Manuals