LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rocker molding to the holes in the rocker panel.
  2. Install the rocker molding starting to the first net hole (1) then the second net hole (2) and then the third net hole (3). Press the push-in retainers into place until fully seated.
    Fig 1: Locating Rocker Molding Push-In Retainers
    GM621023Courtesy of GENERAL MOTORS CORP.
  3. Install the push-in retainers to the lower rocker molding, pressing into place until fully seated.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the rocker molding screw to the rocker molding.

    Tighten:  Tighten the screw to 6 N.m (53 lb in).

    Fig 2: View Of Rocker Panel Push-In Retainers
    GM621022Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals