LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Door Body Side (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the lower support retainer with the notch down and the retainers to the holes in the door panel.
    Fig 1: View Of Rear Door Body Side Molding Lower Support
    GM622282Courtesy of GENERAL MOTORS CORP.
  2. Install the center pins of the retainers using a small hammer.
    Fig 2: Installing Center Pins In Retainer
    GM622269Courtesy of GENERAL MOTORS CORP.
  3. Position the lower support retainer with the notch down and the retainers to the holes in the door panel.
    Fig 3: View Of Rear Door Body Side Molding Rear Support
    GM626952Courtesy of GENERAL MOTORS CORP.
  4. Install the center pins of the retainers using a small hammer.
    Fig 4: Inserting Center Pins In Rear Support Retainer
    GM622284Courtesy of GENERAL MOTORS CORP.
  5. Use a heat gunJ 25070  .
  6. Position the lower flange of the rear door body side molding to the retainer support and align the tab to the notch in the retainer support.
    Fig 5: Aligning Rear Door Body Side Molding
    GM621060Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not touch the adhesive backing on the molding.
  7. Remove the protective liner from the back side of the door body side molding.
  8. Position the upper edge of the rear door body side molding retainer clips to the holes in the door panel.
  9. Install the retainer clips to the door panel by pressing in until fully seated.
  10. Install the upper edge of the rear door body side molding by applying pressure to the entire length of the molding starting at the center and working outward to ensure a maximum bond to the door panel.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  11. Install the screws to the rear edge of the rear door body side molding.

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

    Fig 6: Locating Rear Door Body Side Molding Rear Edge Screws
    GM618051Courtesy of GENERAL MOTORS CORP.
  12. Close the rear door.
scientia non olet · About LEMON Manuals