Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Position the lift gate upper molding to the lift gate.
NOTE: Refer to Fastener Notice in Cautions and Notices.
- Install the lift gate upper molding screws.
Tighten: Tighten the screws to 2.0 N.m (18 lb in).
- Install the lift gate lower molding. Refer to Molding Replacement - Liftgate Lower .
- Install the lift gate applique. Refer to Liftgate Applique Replacement in Body Rear End.
- Install the lift gate handle. Refer to Handle Replacement - Endgate in Body Rear End.