Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Align the lift gate lower molding to the tabs in the upper molding.

Fig 1: Identifying Lift Gate Lower Molding
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the lift gate lower molding screws.
Tighten: Tighten the screws to 2.0 N.m (18 lb in).

Fig 2: View Of Open Lift Gate
Courtesy of GENERAL MOTORS CORP.
Close the rear lift gate.