LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Door (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the location of the emblem/nameplate has not been marked apply tape and use the following dimensions:
    • Dimension (a) is 19.5 mm (0.78 in) above the feature line on the door.
    • Dimension (b) is 68.7 mm (2.7 in) from the front edge of the door.
    Fig 1: View Of Emblem/Nameplate (Rendezvous)
    GM755156Courtesy of GENERAL MOTORS CORP.
  2. Warm the door surface with a heat gun J 25070  152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
    Fig 2: Using J 25070 To Apply Heat
    GM429763Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not touch the adhesive backing of the emblem/nameplate.
  3. Remove the backing from the front end of the emblem/nameplate.
  4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
  5. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
  6. Inspect the emblem/nameplate for bonding.
  7. Remove the tape from the area around the door emblem.
scientia non olet · About LEMON Manuals