LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Exterior Trim) >> Repair Instructions >> Emblem Replacement - Hood >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Heat the hood emblem and mounting surface to approximately 21°C (70°F) using the J 25070  , if necessary.
    IMPORTANT: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion. Do not touch the adhesive backing on the emblem/nameplate.
  2. Remove the protective liner from the back of the hood emblem.
  3. Position the hood emblem locating pins to the holes in the hood.
    Fig 1: Locating Hood Emblem Mounting Nuts
    GM755122Courtesy of GENERAL MOTORS CORP.
  4. Apply equal pressure along the emblem to uniformly bond the emblem to the hood.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the hood emblem nuts to the hood emblem.

    Tighten:  Tighten the nuts to 2.0 N.m (18 lb in).

  6. Remove the masking tape from the hood.
  7. Close the hood.
scientia non olet · About LEMON Manuals