LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1113 (Body Front End) >> Repair Instructions >> Seal Replacement - Plenum to Hood >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the hood rear weatherstrip to the holes in the cowl under the air inlet grille.
    Fig 1: View Of Hood Rear Weatherstrip
    GM624419Courtesy of GENERAL MOTORS CORP.
  2. Install the push-in retainers to the hood rear weatherstrip.
  3. Close the hood.