LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1113 (Body Front End) >> Repair Instructions >> Seal Replacement - Hood Rear Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the protective backing paper from the adhesive on the rear side hood seal.
  2. Install the rear side hood seal to the pinch-weld flange and motor compartment flange.
    Fig 1: Identifying Rear Side Hood Seal
    GM624418Courtesy of GENERAL MOTORS CORP.
  3. Press the side rear hood seal onto the pinch-weld flange and motor compartment flange until the adhesive is fully adhered.
  4. Close the hood.
scientia non olet · About LEMON Manuals