LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1113 (Body Front End) >> Repair Instructions >> Brace Replacement - Front Fender Upper Diagonal - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Reposition the underhood wiring junction block from the front fender diagonal brace. Refer to Underhood Electrical Center or Junction Block Replacement in Wiring Systems.
    Fig 1: Identifying Underhood Wiring Junction Block
    GM621983Courtesy of GENERAL MOTORS CORP.
  3. Remove the bolt from the front end sheet metal diagonal brace at the inner fender.
    Fig 2: Locating Front End Sheet Metal Diagonal Brace Bolts
    GM621980Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts from the front end sheet metal diagonal brace at the radiator support.
  5. Remove the front end sheet metal diagonal brace.
    Fig 3: Front End Sheet Metal Diagonal Brace
    GM621982Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals