Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Open and support the hood.
Lift up the retainer clips on the assist rod using a small flat-bladed tool.

Fig 1: Using Flat Bladed Tool To Lift Assist Rod Retainer Clips
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Liftgate/Hood Assist Rod Notice in Cautions and Notices.
Pull the upper end of the assist rod from the ball joint on the hood.

Fig 2: View Of Assist Rod
Courtesy of GENERAL MOTORS CORP.
Pull the lower end of the assist rod from the ball joint on the lower hood hinge.