LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1113 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Remove the windshield wiper arms. Refer to Wiper Arm Replacement in Wiper Washer Systems.
  3. Reposition the windshield wiper washer hose from the air inlet grille.
    Fig 1: View Of Windshield Wiper Washer Hose
    GM611434Courtesy of GENERAL MOTORS CORP.
  4. Remove the push-in retainers from the air inlet grille, using the J 38778  . See Special Tools and Equipment .
    Fig 2: Identifying Air Inlet Grille Push-In Retainers
    GM621321Courtesy of GENERAL MOTORS CORP.
  5. Remove the air inlet grille extensions from the air inlet grille at the windshield.

    Pull up and out in order to release the retainers on the air inlet grille extensions.

    Fig 3: Locating Air Inlet Grille Extensions
    GM621324Courtesy of GENERAL MOTORS CORP.
  6. Remove the air inlet grille from the vehicle.
    Fig 4: View Of Air Inlet Grille
    GM621322Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals