LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1113 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Inspect the position of the air inlet seal to the windshield. If not seated properly, reposition the air inlet grille as required.
  1. Position the air inlet grille to the vehicle.
    Fig 1: View Of Air Inlet Grille
    GM621322Courtesy of GENERAL MOTORS CORP.
  2. Install the air inlet grille extensions to the air inlet grille and the windshield, pressing into place until fully seated.
    3. Fig 2: Locating Air Inlet Grille Extensions
    GM621324Courtesy of GENERAL MOTORS CORP.
  3. Install the push-in retainers to the air inlet grille.
    Fig 3: Identifying Air Inlet Grille Push-In Retainers
    GM621321Courtesy of GENERAL MOTORS CORP.
  4. Reposition the windshield wiper washer hose to the air inlet grille.
    Fig 4: View Of Windshield Wiper Washer Hose
    GM611434Courtesy of GENERAL MOTORS CORP.
  5. Install the windshield wiper arms. Refer to Wiper Arm Replacement in Wiper Washer Systems.
  6. Close the hood.
scientia non olet · About LEMON Manuals