LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Retained Accessory Power System) >> Diagnostic Information and Procedures >> Retained Accessory Power (RAP) On After Timeout

Retained Accessory Power (RAP) On After Timeout

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Retained Accessory Power (RAP) On After Timeout

Step Action Yes No
Schematic Reference: Retained Accessory Power (RAP) Schematics 
Connector End View Reference: Master Electrical Component List in Wiring Systems
1 Did you perform the Diagnostic System Check for the retained accessory power (RAP) system? Go to Step 2  Go to Diagnostic System Check - Retained Accessory Power 
2
  1. Turn the ignition switch to the LOCK position.
  2. Disconnect the RAP relay.
  3. Check the power windows and sunroof for correct operation.
Do the sunroof and the power windows operate?		 Go to Step 3  Go to Step 5 
3
  1. Disconnect the console electrical center.
  2. Test for a short to battery in the power windows and sunroof feed circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 4 
4 Replace the console electrical center. Refer to Console Electrical Center or Junction Block Replacement in Wiring Systems.
Did you complete the replacement?		 Go to Step 10  -
5
  1. Open one of the car doors.
  2. Probe the RAP relay control circuit with a test lamp connected to a good ground.
Does the test lamp illuminate?		 Go to Step 7  Go to Step 6 
6 Replace the RAP relay.
Did you Complete the replacement?		 Go to Step 10  -
7 Test the RAP relay control circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 8 
8 Inspect for poor connections at the console electrical center connector to the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 9 
9
  1. Replace the BCM. Refer to Body Control Module Replacement in Body Control System.
  2. Perform the set up procedure for the new BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System.
Did you complete the replacement and the set up procedure?		 Go to Step 10  -
10 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals