LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1109 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Rear Bumper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Position the left side first, then the right side.
  1. Position the impact bar to the body using the alignment pin for location.
    Fig 1: Identifying Impact Bar
    GM621389Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the impact bar bolts.

    Tighten:  Tighten the impact bar bolts to 50 N.m (37 lb ft).

    Fig 2: View Of Impact Bar Bolts
    GM621387Courtesy of GENERAL MOTORS CORP.
  3. Install the energy absorber. Refer to Energy Absorber Replacement - Rear (Aztek)  or Energy Absorber Replacement - Rear (Rendezvous)  .
  4. Install the rear bumper fascia. Refer to Fascia Replacement - Rear Bumper (Aztek)  or Fascia Replacement - Rear Bumper (Rendezvous)  .
scientia non olet · About LEMON Manuals