LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1109 (Bumper System) >> Repair Instructions >> Fascia Support Replacement - Front Bumper Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fascia upper support to the upper radiator support.
    Fig 1: Identifying Fascia Upper Support
    GM621384Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts to the fascia upper support.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

  3. Install the bolts to the fascia lower support.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Connect the headlamp wiring harness to the fascia upper support.
    Fig 2: View Of Headlamp Wiring Harness
    GM621383Courtesy of GENERAL MOTORS CORP.
  5. Install the hood latch and cable. Refer to Hood Latch Release Cable Replacement .
  6. Install the front bumper fascia. Refer to Fascia Replacement - Front Bumper - Upper (Aztek)  or Fascia Replacement - Front Bumper - Upper (Rendezvous)  .
scientia non olet · About LEMON Manuals