Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Install the grommets to the rear pillar, if removed.

Fig 1: View Of Rear Bumper Fascia (Aztek)
Courtesy of GENERAL MOTORS CORP.
Position the rear bumper fascia to the vehicle.
Install the rear bumper fascia tabs to the rear quarter moldings.

Fig 2: Locating Rear Bumper Fascia Push-In Retainers To Rear Impact Bar (Aztek)
Courtesy of GENERAL MOTORS CORP.
Starting at the center hole, install the push-in retainers to the lower rear bumper fascia.
Install the push-in retainers to the rear bumper fascia upper tabs.

Fig 3: Identifying Rear Bumper Fascia Upper Tab Push-In Retainers (Aztek)
Courtesy of GENERAL MOTORS CORP.
Install the rear bumper fascia push-in retainers to the inboard side of the rear quarter panel.

Fig 4: View Of Rear Bumper Fascia Inboard Side Push-In Retainers (Aztek)
Courtesy of GENERAL MOTORS CORP.
Close the endgate.