LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1109 (Bumper System) >> Repair Instructions >> Fascia Replacement - Front Bumper - Lower (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front fender liners. Refer to Front Fender Liner Replacement in Body Front End.
  2. Remove the headlamps. Refer to Headlamp Assembly or Headlamp Bulb Replacement (Aztek) or Headlamp Assembly or Headlamp Bulb Replacement (Rendezvous) in Lighting Systems.
  3. Remove the fog lamps. Refer to Fog Lamp Replacement - Front (Aztek) or Fog Lamp Replacement - Front (Rendezvous) in Lighting Systems.
  4. Remove the bolts from the front bumper fascia at the fender.
    Fig 1: View Of Front Bumper Fascia Bolts (Aztek)
    GM621470Courtesy of GENERAL MOTORS CORP.
  5. Remove the push-in retainers from the upper bumper fascia support using J 38778  .
    Fig 2: Identifying Upper Bumper Fascia Support Push-In Retainers (Aztek)
    GM621471Courtesy of GENERAL MOTORS CORP.
  6. Remove the push-in retainers to the fascia at the front bumper energy absorber using J 38778  .
    Fig 3: Locating Front Bumper Energy Absorber Push-In Retainers (Aztek)
    GM621467Courtesy of GENERAL MOTORS CORP.
  7. Remove the fascia from the vehicle.
  8. Remove the grilles from the fascia. Refer to Fascia Grille Replacement (Aztek)  or Fascia Grille Replacement (Rendezvous)  .
  9. Remove the fascia outer support from the fascia.
  10. Remove the upper fascia from the lower fascia.
    Fig 4: View of Upper & Lower Fascia (Aztek)
    GM892123Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals