Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Position your fingers between the headliner and the information center telltale assembly bezel and gently pull down to release the display bezel retainers.

Fig 1: Positioning Fingers Between Headliner & Information Center Telltale Assembly Bezel
Courtesy of GENERAL MOTORS CORP.
Use a small flat-bladed tool to release the locking tab at the rear of the telltale assembly.

Fig 2: Pressing Down On Lock Tab On Telltale Assembly
Courtesy of GENERAL MOTORS CORP.
Tilt the information center telltale assembly down and pull down to remove.

Fig 3: View Of Information Center Telltale Assembly
Courtesy of GENERAL MOTORS CORP.
Disconnect the electrical connector from the information center telltale assembly.