LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement - Rear Seat (Bucket) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear seat cushion trim cover from the rear seat.
    2. Fig 1: View Of Rear Seat Cushion Trim Cover
    GM627493Courtesy of GENERAL MOTORS CORP.
  2. Install the upper retainer clip to the seat frame, pressing into place until fully seated.
    3. Fig 2: Locating Rear Seat Cushion Trim Cover Rear Screw
    GM627483Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the rear screw to the seat cushion trim cover.

    Tighten:  Tighten the rear seat cushion trim cover screw to 2 N.m (18 lb in).

    4. Fig 3: Identifying Rear Seat Recliner Handle Screw
    GM627484Courtesy of GENERAL MOTORS CORP.
  4. Install the rear seat recliner handle.
  5. Install the rear bucket seat to the vehicle. Refer to Seat Replacement - Rear Bucket .
scientia non olet · About LEMON Manuals