LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement - Front Seat >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Front Seat Lumbar Control Knob
    GM626943Courtesy of GENERAL MOTORS CORP.
  1. Remove the front seat lumbar control knob by pulling off.
    2. Fig 2: Locating Front Seat Back Recliner Handle Screws
    GM626945Courtesy of GENERAL MOTORS CORP.
  2. Remove the front seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front .
    3. Fig 3: View Of Front Seat Cushion Trim Panel Screws (Rear)
    GM626984Courtesy of GENERAL MOTORS CORP.
  3. Place the front bucket seat to the most rearward position.
  4. Remove the screw from the rear of the front seat cushion trim panel.
    5. Fig 4: Locating Front Seat Cushion Trim Panel Screws (Front)
    GM626985Courtesy of GENERAL MOTORS CORP.
  5. Place the front bucket seat to the most forward position.
  6. Remove the screw from the front of the front seat cushion trim panel.
    7. Fig 5: Center Seat Cushion Trim Panel Screws
    GM631092Courtesy of GENERAL MOTORS CORP.
  7. Remove the screw from the center of the front seat cushion trim panel.
  8. Remove the front seat cushion trim panel from the front seat.
  9. Remove the power seat switch from the front seat cushion trim panel, if equipped.
  10. Remove the front seat cushion trim panel from the vehicle.
scientia non olet · About LEMON Manuals