LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Cushion Inner Trim Panel Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Seat Cushion Trim Panel
    GM631091Courtesy of GENERAL MOTORS CORP.
  1. Install the front seat cushion trim panel from the front bucket seat.
    2. Fig 2: Locating Front Seat Cushion Trim Panel Center Screw
    GM631294Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screw to the center of the front seat cushion trim panel.

    Tighten:  Tighten the front seat cushion trim panel center screw to 43 N.m (32 lb ft).

    3. Fig 3: Identifying Front Seat Cushion Trim Panel Front Screw
    GM626888Courtesy of GENERAL MOTORS CORP.
  3. Install the screw to the front of the front seat cushion trim panel.

    Tighten:  Tighten the front seat cushion trim panel front screw to 43 N.m (32 lb ft).

    4. Fig 4: View Of Front Seat Cushion Trim Panel Rear Screw
    GM626929Courtesy of GENERAL MOTORS CORP.
  4. Install the screw to the rear of the front seat cushion trim panel.

    Tighten:  Tighten the front seat cushion trim panel rear screw to 43 N.m (32 lb ft).

  5. Install the front bucket seat. Refer to Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals