LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Cushion Heater Element Replacement - Front (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat cushion heater element.
    2. Fig 1: Identifying Hog Rings
    GM627178Courtesy of GENERAL MOTORS CORP.
  2. Install the cover onto the front seat cushion.
  3. Install the hog rings to the front seat cushion cover.
    4. Fig 2: View Of Heated Seat Electrical Connector
    GM627157Courtesy of GENERAL MOTORS CORP.
  4. Install the J-hook retainer on the front of the cover.
    5. Fig 3: Identifying J-Hook Retainer
    GM627169Courtesy of GENERAL MOTORS CORP.
  5. Install the J-hook retainers on the sides of the cover.
    6. Fig 4: View Of Rear J-Hook Retainer
    GM627173Courtesy of GENERAL MOTORS CORP.
  6. Install the J-hook retainer on the rear of the cover.
    7. Fig 5: Locating Seat Cushion Hook & Loop Retainers
    GM627480Courtesy of GENERAL MOTORS CORP.
  7. Install the hook and the loop retainers securing the cover to the cushion, by pressing in place until fully seated.
  8. Install the seat adjuster. Refer to Seat Adjuster Replacement - Front .
  9. Connect the electrical connector for the heated seat, if equipped.
  10. Install the seat back. Refer to Seat Back Replacement - Front .
  11. Install the bucket seat. Refer to Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals