LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Cushion Cover Replacement - Front (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bucket seat from the vehicle. Refer to Seat Replacement - Bucket .
  2. Remove the front seat back. Refer to Seat Back Replacement - Front .
  3. Remove the front seat adjuster. Refer to Seat Adjuster Replacement - Front .
  4. Disconnect the electrical connector for the heated seat, if equipped.
    5. Fig 1: View Of Heated Seat Electrical Connector
    GM627157Courtesy of GENERAL MOTORS CORP.
  5. Remove the J-hook retainers on the front of the front seat cushion cover.
    6. Fig 2: Identifying J-Hook Retainer
    GM627169Courtesy of GENERAL MOTORS CORP.
  6. Remove the J-hook retainers on the sides of the front seat cushion cover.
    7. Fig 3: View Of Rear J-Hook Retainer
    GM627173Courtesy of GENERAL MOTORS CORP.
  7. Remove the J-hook retainers on the rear of the front seat cushion cover.
    8. Fig 4: Locating Seat Cushion Hook & Loop Retainers
    GM627480Courtesy of GENERAL MOTORS CORP.
  8. Remove the hook and the loop retainers securing the seat cushion cover to the cushion.
    9. Fig 5: Identifying Hog Rings
    GM627178Courtesy of GENERAL MOTORS CORP.
  9. Remove the hog rings from the front seat cushion cover.
  10. Remove the front seat cushion cover from the front seat cushion.
scientia non olet · About LEMON Manuals