Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Remove the split bench seat. Refer to Seat Replacement - Rear 50-50 Split .
Remove the back trim panel from the rear seat. Refer to Trim Panel Replacement - Rear Seat Back .
Remove the outer trim panel from the rear seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement - Rear Seat (Bucket) or Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench) .

Fig 1: Locating Rear Center J-Hook Retainers

Courtesy of GENERAL MOTORS CORP.

Remove the lower J-hook retainer and pull back the cushion cover to expose the recliner hinge and the center pivot point.

Fig 2: Identifying Seat Back Recliner Hinge Upper Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the upper bolts from the seat back recliner hinge.

Fig 3: Locating Rear Seat Back Pivot Stud

Courtesy of GENERAL MOTORS CORP.

Remove the seat back from the inner pivot point by lifting up the outer end of the seat back. Use a quick upward twist to disengage the pivot stud from the pivot socket.