LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Back Replacement - Rear (Bucket) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Seat Back
    GM627407Courtesy of GENERAL MOTORS CORP.
  1. Place the rear seat back to the rear seat cushion frame.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: View Of Seat Back Recliner Hinge Left Front Bolts
    GM627009Courtesy of GENERAL MOTORS CORP.
  2. Install the bolts to the seat back recliner hinges.

    Tighten:  Tighten the bolts to 40 N.m (30 lb ft).

  3. Install the outer trim panel to the rear seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement - Rear Seat (Bucket)  or Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench) .
  4. Install the inner trim panel to the rear seat cushion. Refer to Seat Cushion Inner Panel Replacement - Rear .
  5. Inspect the seat back for proper operation.
  6. Install the rear bucket seat. Refer to Seat Replacement - Rear Bucket .
scientia non olet · About LEMON Manuals