LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Back Recliner Replacement - Rear (Split Bench) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear split bench seat. Refer to Seat Replacement - Rear 50-50 Split .
  2. Remove the outer trim panel from the seat cushions. Refer to Seat Cushion Outer Trim Panel Replacement - Rear Seat (Bucket)  or Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench) .
    3. Fig 1: Identifying Seat Back Recliner Hinge Upper Bolts
    GM629131Courtesy of GENERAL MOTORS CORP.
  3. Move the seat back cover and the pad away in order to expose the seat back recliner bolts.
  4. Remove the bolts from the seat back recliner.
    5. Fig 2: View Of Seat Back Recliner
    GM629121Courtesy of GENERAL MOTORS CORP.
  5. Remove the recliner from the seat.
    6. Fig 3: Seat Back Recliner Inner Side
    GM629192Courtesy of GENERAL MOTORS CORP.
  6. If required, remove the trim cover from the seat back recliner inner side.
scientia non olet · About LEMON Manuals