LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Back Recliner Replacement - Rear (Split Bench) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Back Recliner Inner Side
    GM629192Courtesy of GENERAL MOTORS CORP.
  1. If required, install the trim cover to the inner side of the seat back recliner.
    2. Fig 2: View Of Seat Back Recliner
    GM629121Courtesy of GENERAL MOTORS CORP.
  2. Install the seat back recliner to the seat.
    3. Fig 3: Identifying Seat Back Recliner Hinge Upper Bolts
    GM629131Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts to the seat back recliner.

    Tighten:  Tighten the bolts to 40 N.m (30 lb ft).

  4. Move the cover and the pad over the seat back recliner bolts.
  5. Install the outer trim panel to the seat cushions. Refer to Seat Cushion Outer Trim Panel Replacement - Rear Seat (Bucket)  or Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench) .
  6. Install the split bench seat. Refer to Seat Replacement - Rear 50-50 Split .
scientia non olet · About LEMON Manuals