LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Back Recliner Replacement - Rear (Bucket) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bucket seat. Refer to Seat Replacement - Rear Bucket .
  2. Remove the outer trim panel from the rear seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement - Rear Seat (Bucket)  or Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench) .
  3. Remove the inner trim panel from the rear seat cushion. Refer to Seat Cushion Inner Panel Replacement - Rear .
    4. Fig 1: Locating Seat Back Recliner Cable Retainer
    GM627019Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the cable retainer from the seat back recliner, pushing up on the retainer.
    5. Fig 2: View Of Cable Ends & Seat Back Recliner Hinge
    GM627012Courtesy of GENERAL MOTORS CORP.
  5. Remove the cable from the seat back recliner.
    6. Fig 3: View Of Seat Back Recliner Hinges Bolts
    GM627496Courtesy of GENERAL MOTORS CORP.
  6. Move away the seat back cover and pad in order to expose the seat back recliner bolts.
  7. Remove the bolts from the seat back recliner.
  8. Remove the recliner from the seat.
scientia non olet · About LEMON Manuals