LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Back Recliner Handle Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The keys on the recliner handle must properly align to the keyways on the recliner handle shaft.
    Fig 1: Identifying Seat Back Recliner Handle
    GM626956Courtesy of GENERAL MOTORS CORP.
  1. Position the seat back recliner handle to the seat back recliner handle shaft.
  2. Install the seat back recliner handle to the seat back recliner handle shaft pressing on until properly seated.
    3. Fig 2: Locating Front Seat Back Recliner Handle Screws
    GM626945Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screw to the seat back recliner handle.

    Tighten:  Tighten the seat back recliner screw to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals