LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Back Cover Replacement - Rear (Split Bench) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear split bench seat. Refer to Seat Replacement - Rear 50-50 Split .
  2. Remove the rear seat back trim panel. Refer to Trim Panel Replacement - Rear Seat Back .
  3. Remove the rear seat back from the rear seat. Refer to Seat Back Replacement - Rear (Split Bench)  or Seat Back Replacement - Rear (Bucket) .
  4. Remove the rear seat headrest. Refer to Head Restraint Replacement - Rear Seat .
    5. Fig 1: Locating J-Hook Retainer At Bottom Of Seat Back Cover
    GM629118Courtesy of GENERAL MOTORS CORP.
  5. Remove the J-hook retainer at the bottom of the seat back cover.
    6. Fig 2: View Of Rear Seat Back Cover End Flaps
    GM629126Courtesy of GENERAL MOTORS CORP.
  6. Pull out the rear seat back cover end flaps.
    7. Fig 3: Identifying Hog Rings On Rear Seat Back Cover
    GM629128Courtesy of GENERAL MOTORS CORP.
  7. Remove the hog rings from the rear seat back cover to the pad.
  8. Remove the hook and the loop retainers securing the rear seat back cover to the pad.
    9. Fig 4: Pulling Rear Seat Back Cover Up & Over Pad
    GM629141Courtesy of GENERAL MOTORS CORP.
  9. Remove the rear seat back cover from the seat back, by pulling the seat back cover up and over the pad.
    10. Fig 5: View Of Rear Seat Back Cover
    GM629143Courtesy of GENERAL MOTORS CORP.
  10. Remove the rear seat back cover from the pad.
scientia non olet · About LEMON Manuals