LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Back Cover Replacement - Rear (Split Bench) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Seat Back Cover
    GM629143Courtesy of GENERAL MOTORS CORP.
  1. Install the rear seat back cover to the pad.
    2. Fig 2: Installing Rear Seat Back Cover
    GM629142Courtesy of GENERAL MOTORS CORP.
  2. Install the rear seat back cover to the seat back, by pulling the seat back cover down and over the pad.
    3. Fig 3: Identifying Hog Rings On Rear Seat Back Cover
    GM629128Courtesy of GENERAL MOTORS CORP.
  3. Install the hog rings to the rear seat back cover to the pad.
    4. Fig 4: Locating J-Hook Retainer At Bottom Of Seat Back Cover
    GM629118Courtesy of GENERAL MOTORS CORP.
  4. Install the J-hook retainer at the bottom of the seat back cover.
  5. Install the hook and the loop retainers securing the rear seat back cover to the pad.
  6. Install the rear seat back trim panel.
  7. Install the rear seat back to the rear seat. Refer to Seat Back Replacement - Rear (Split Bench)  or Seat Back Replacement - Rear (Bucket) .
  8. Install the rear seat headrest. Refer to Head Restraint Replacement - Rear Seat .
  9. Install the rear seat back trim panel. Refer to Trim Panel Replacement - Rear Seat Back .
  10. Install the rear split bench seat. Refer to Seat Replacement - Rear 50-50 Split .
scientia non olet · About LEMON Manuals