LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Seat Back Cover Replacement - Rear (Bucket) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Hog Rings
    GM627478Courtesy of GENERAL MOTORS CORP.
  1. Install the rear seat back cover alignment mark to the alignment mark on the pad.
  2. Install the hog rings to the rear seat back cover to the pad.
  3. Install the seat back cover over the pad and alining the hook and the loop retainers.
  4. Install the hook and the loop retainers, securing the rear seat back cover to the pad.
    5. Fig 2: Aligning Front Seat Back Cover End Flap
    GM627455Courtesy of GENERAL MOTORS CORP.
  5. Install the rear seat back cover end flap.
    6. Fig 3: Installing J-Hook Retainer
    GM627454Courtesy of GENERAL MOTORS CORP.
  6. Install the J-hook retainer at the bottom of the seat back cover.
  7. Install the rear seat back to the rear seat. Refer to Seat Back Replacement - Rear (Split Bench)  or Seat Back Replacement - Rear (Bucket) .
  8. Install the rear seat headrest. Refer to Head Restraint Replacement - Rear Seat .
  9. Install the rear seat back trim panel. Refer to Trim Panel Replacement - Rear Seat Back .
  10. Install the rear bucket seat. Refer to Seat Replacement - Rear Bucket .
scientia non olet · About LEMON Manuals