LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Lumbar Adjuster Support Replacement - Manual >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bucket seat. Refer to Seat Replacement - Bucket .
  2. Remove the outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement - Front Seat .
    3. Fig 1: Identifying Lumbar Control Cable
    GM627458Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The lumbar support must be in the relaxed position to disconnect the lumbar support cable.
  3. Remove the lumbar control cable from the lumbar control.
    4. Fig 2: Locating Lumbar Control Screws
    GM627459Courtesy of GENERAL MOTORS CORP.
  4. Remove the screws from the lumbar control.
  5. Remove the lumbar control from the seat cushion frame.
scientia non olet · About LEMON Manuals