Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Lumbar Control Screws

Courtesy of GENERAL MOTORS CORP.

Install the lumbar control to the seat cushion frame.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws to the lumbar control.
Tighten: Tighten the screws to 10 N.m (89 lb in).

Fig 2: Identifying Lumbar Control Cable

Courtesy of GENERAL MOTORS CORP.

Install the lumbar control cable to the lumbar control.
Install the outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement - Front Seat .
Install the front bucket seat. Refer to Seat Replacement - Bucket .